Quality Inspector II - 2nd Shift

What you’ll do:

Reports to the Quality Supervisor or designated authority. Responsible for performing in-process and/or outbound dimensional and visual inspections of component parts, assemblies, and sub-assemblies as required.

• Perform dimensional inspections using CMM equipment, including executing approved CMM programs and verifying inspection results.
• Interpret and inspect to engineering drawings, GD&T, specifications, and quality requirements.
• Review and verify inspection results for accuracy, completeness, and compliance.
• Generate and maintain inspection records and reports in accordance with Eaton and customer requirements.
• Inspects (receiving, in-process and outbound) aerospace component parts, sub-assemblies and/or assemblies visually and dimensionally for conformance to manufacturing drawings, quality control specifications and supplier/customer requirements. Other duties and/or responsibilities may be performed as part of cross-training or employee development plan.
• Responsible for review and acceptance of paperwork and documentation used in the acceptance of product.
• Responsible to produce necessary manual or computer generated inspection reports to accept or reject products.
• Inspection involves using measurement equipment such as, but not limited to, calipers, micrometers, pin gages, thread plugs, thread ring gages, surface plates, and optical comparator.
• Completes data processing move transactions as required.
• Possesses basic understanding of geometrical tolerancing and dimensional measurements per ASME Y14.5.
• Possesses in-depth knowledge of AQL sampling selection per internal procedures or ANSI/ASQC Z1.4 or as directed by customers.
• Possesses minimum of five years of experience in first article inspection reports per AS9102.
• Possesses in-depth knowledge of acceptance test procedures (ATP), acceptance test reports (ATR), job travelers (process plans), pick lists, drawings, procedures, C of Cs, chemical & physical analysis reports, and test reports.
• Evaluates and adheres to all flowed down contractual (internal and external) requirements of customer purchase orders, suppliers purchase orders for commercial and/or military products.

Qualifications:

Basic (Required) Qualifications:

• Must have a high school diploma or GED from an accredited institution.

• A minimum of three (3) years related experience or training; or equivalent combination of education and experience in mechanical inspection of aerospace products.

• Minimum of two (2) years of related experience or training performing dimensional inspections using CMM equipment.

• Relocation is not offered for this role. Candidates must reside within a 50 mile distance of the Irvine , CA facility  to be considered.

• This position requires use of information or access to hardware which is subject to the International Traffic in Arms Regulations (ITAR). All applicants must be U.S. persons within the meaning of ITAR. ITAR defines a U.S. person as a U.S. Citizen, U.S. Permanent Resident (i.e. 'Green Card Holder'), Political Asylee, or Refugee

• Eaton will not consider applicants for employment immigration sponsorship or support for this position.  This means that Eaton will not support any CPT, OPT, or STEM OPT plans, F-1 to H-1B, H-1B cap registration, O-1, E-3, TN status, I-485 job portability, etc.

Preferred Qualifications:

• Knowledge  or experience inspecting various types of materials (e.g., aluminum, alloy, titanium, stainless steel, etc.).
• Knowledge or experience inspecting aerospace products with coatings (e.g., anodizing, cadmium plating, chromium plating, nickel plating, zinc plating, passivation, etc.).
• College or ASQ (American Society for Quality) certification a plus.
• Experience working in FAA environment
• In-depth knowledge of DFAR and Nadcap requirements.
• Basic knowledge of customers’ DQCR/DSQR programs and website portals.

#IND123

#LI-LB1